Core drilling, with limited & difficult access

If you're in search of reliable core drilling services in Victoria, Wylies Concrete Cutting has you covered.

Core Drilling, With Limited & Difficult Access

Core drilling inside a 2.4mtr diam shaft 10mtrs below ground into a curved surface 800mm diam core x approx 900/1000mm deep including core drilling out the steel sheet piling web joint + piling plate / 50mm deep, steel joint, at the backend of the core

Core drilling limited and difficult access no problems. Core drilling in limited access in remote country regional areas.

Core drilling 300mm diam x 1300mm deep on a specific angle with difficulties inside the core due to gravel/crushed rock/ this loose material causes binding issues when cutting loose rebar/ steel inside the core not encased in concrete, and binding issues when removing the core once cut thru.

A skilled professional known as Mark Wylie of Wylies Concrete Cutting is proficient in small bore core drilling in limited and difficult environments. With specialised enquiries, this service could go even deeper than the 10 metres.

The successful completion of more than three hundred cores shows Mark’s expertise and demonstrates an accuracy of +-1.5mm for deflection at ten metres depth in blind holes. Meeting the challenges of restricted access with skill and cleverness.

Wylies Concrete Cutting ensures not only accomplishment but accuracy for each task undertaken. Mark Wylie’s concrete cutting service is dedicated to quality, attention to details, and excellence and therefore offers unmatched expertise in the industry.

Trust Wylies Concrete Cutting to handle the complexity of small-hole core drilling and customised services for your specific requirements

Note; the diam and angle of the core was calculated to allow 2 x electrical conduits, 90 deg bend x 125mm diam to be installed as per normally in the upright position with the end of the conduit flush against the wall, with the other end at the industry spec depth, then the wire could be pulled thru, same as a new build, prior to constructions 😊.

For more details to suit your job, complete and send the enquire slip, noted below:

Customer got more than he bargained for 700mm diam x 700mm deep on 2 x angles on inclination, and extremely difficult to attach a core drill suitable to complete the angled works and sized penetration, and to adjust the core to exactly and accurately as required, on a minimum undulating almost impossible surface, expectations sometimes !! With another surprise, customer wanted as a last minute request, no problems, works completed as required

Core drilling concrete blisters off flush, from neighbours property, over a limited access 700mm wide garden bed, interesting challenge, it is noted the photo does not do credit to the difficulties as it was also tucked into a corner x 1.5mtrs long along the boundary line.

The wall was not meant to be vertical, but had a vertical and longitudinally, discrepancy of 15mm and the concrete grew to 700mm deep, interesting challenge, resulting in a happy completion, no problems, and thank you for the opportunity.